DA42 v DA62 Training Options

Post a reply


This question is a means of preventing automated form submissions by spambots.
Smilies
:) :D :lol: :( 8) ;) :scream: :scratch: :tap: :P :shock: :thumbsup: :thumbsd: :oops: 8) 8-) :x :cry: :roll: :!: :?: :idea: :arrow: :mrgreen: :bow :^ :< :-
View more smilies

BBCode is ON
[img] is ON
[flash] is OFF
[url] is ON
Smilies are ON

Topic review
   

Expand view Topic review: DA42 v DA62 Training Options

Re: DA42 v DA62 Training Options

by NDCDA62 » Thu Jun 18, 2020 8:48 am

I would agree with Papa Sierra’s comments.

If you are going to fly a DA62 anyway and can afford the 2k difference, then I would train in the DA62. I did my DA62 Systems Training and MEP at Diamond Wiener Neustadt which also suggest you consider as the knowledge imparted was invaluable. The manual provided for the course is the ultimate DA62 “bible”.

I transitioned from a PA28 (6-Pack) to a DA40 NG (G1000) and then the DA62. The DA40 was a great training ground to experience the G1000.

I would recommend “The Concise Guide to the Diamond DA62” by John Ewing, available on line as an eBook.

Re: DA42 v DA62 Training Options

by CFIDave » Tue Jun 16, 2020 2:11 pm

As long as the DA42 has Austro engines and a GFC700 autopilot (e.g., an NG or -VI model), save yourself considerable money by training in the 42. The transition is trivial with very few differences:
- DA62 normally uses takeoff flaps, DA42 not
- No stick limiter in the DA62
- The wider scimitar blades on the DA62 and DA42-VI cause the plane to slow down much more quickly when pulling the power to idle during landing, compared to the skinny "toothpick" blades of the DA42NG (and TDI) models.
- Because of much bigger main gear tires, you can brake harder on the DA62 without accidentally locking up the wheels and creating flat spots (an issue with DA42s)
- Because of the bigger nose wheel tire, the DA62 requires considerably higher pedal pressure to turn while taxiing, forcing you to learn use of differential engine thrust. The 42 is much easier to taxi.

If you train in a DA42 TDI (Thielert/Continential engine), the plane will still handle similarly to a DA62, but has additional differences:
- You have to crank the TDI engines a bit to start whereas Austros start immediately
- TDI aircraft have no electric fuel pump switches to set for takeoffs and landings
- The automated run-up may not cause engine RPM to increase; you only wait for the "ECU Fail" annunciations to disappear
- There is no manual switching between ECU A vs. ECU B on each engine
- Unless the DA42 TDI has been upgraded to GIA63Ws, you probably won't have WAAS, so you won't be able to fly LPV GPS approaches
- And the biggest difference is the TDI's KAP-140 autopilot that's not integrated into the G1000, e.g., setting the altitude bug on the G1000 PFD doesn't help with altitude capture, there is no FLC function to climb at a constant airspeed, no coupled VNAV, etc.

And all of these aircraft have slightly different V-speeds to memorize. :)

Re: DA42 v DA62 Training Options

by papa sierra » Sun Jun 14, 2020 7:45 pm

I was recently in exactly the same situation and ended up choosing to train on the DA62. It's a fabulous machine and you might aswell get used to the aircraft you will be flying.

Don't forget to add the additional costs for airways fees and higher landing fees for a 2.3t aircraft; it added quite an unexpected amount to my training.

One word of warning: If you have not flown with the G1000 before it will be a major distraction and you will find yourself being busy trying to work out the system rather than learning how to fly a multi engine aeroplane. I had about 70 hours on the G1000 but that was quite a while back, and for the first couple of hours on the DA62 it definitely took a lot of attention. Highly recommend to get a G1000 trainer and familiarise yourself with the system; it may even end up being more cost effective to do a few hours on a reasonably priced DA40 G1000 or other single engine aircraft.

Another thing you might want to read is the free FAA training book on multi engine flying: https://www.faa.gov/regulations_policie ... h_ch12.pdf

Out of interest, where is the DA62 you will have access to? Now that I have the MEP and ME-IR I am looking for something to rent on an occasional basis. I'm based in west London and normally fly out of Oxford Kidlington.

Re: DA42 v DA62 Training Options

by ememic99 » Sat Jun 13, 2020 8:07 am

If DA42 is equipped with GFC700, I don’t see much difference, especially for the training purposes.

Re: DA42 v DA62 Training Options

by marioair1 » Fri Jun 12, 2020 4:36 pm

There is quite a cost difference £5000 versus £7000 so trying to see if it's "worth" doing it all on the 62 or doing it (MEP and ME/IR) on the 42 and then doing a conversion afterwards

Also - what are the recommended training I can read up on in advance - the POH(s) obviously but what else. e,g, what G1000 training would people recommend ( i've only ever flow 6-pack and G430)

Re: DA42 v DA62 Training Options

by Marioair1 » Fri Jun 12, 2020 8:20 am

Thanks. I was thinking more going the other way - training in the 42 first. As here in the U.K. there’s a significant cost difference (£6000 versus £8000). So is saving the £2000 worth it versus the extra time is need to then checkout on the 42?

Also - what are good training materials I can read?

Re: DA42 v DA62 Training Options

by jb642DA » Thu Jun 11, 2020 8:56 pm

I owned a DA42 prior to the DA62 -

Like Ultra said - not much difference in the operation of the 62 vs 42-VI.

Since you said insurance isn't an "issue", train in either!

Re: DA42 v DA62 Training Options

by Guest » Thu Jun 11, 2020 8:47 pm

I’ve done both trainings (for DA42 and DA62) based on experience with a DA40NG and can also confirm that there is no big difference between both. I find the DA62 even easier to land because of the larger windmill braking effect below 10%. If would recommend to do the training on the machine you will be flying more in the future, which is the DA62 if I understand correctly?!

Re: DA42 v DA62 Training Options

by Marioair1 » Thu Jun 11, 2020 5:15 pm

I’ve checked and there’s no issue on from an insurance perspective.

So welcome views on that basis

Re: DA42 v DA62 Training Options

by ultraturtle » Thu Jun 11, 2020 3:41 pm

For any given model year, DA62 and DA42-VI are virtually indistinguishable from each other in all respects, to include aircraft performance and feel, so I would not dwell too much on the more expensive DA62 for that reason alone. A more important reason to log as much time in the DA62 as possible would be insurance company requirements. A typical policy in the USA would require a minimum of 5 hours dual in type for the aircraft owner, and anywhere between 25 and 50 hours total time in type for non-owner pilots.

Top